| Model Series | PCC420V |
| Output Signal | 4-20 mA proportional to velocity vibration |
| Output Options | True RMS (R) or calculated peak (P) |
| Frequency Response | 10% from 10 Hz - 1.0 kHz; 3 dB from 3.5 Hz - 2.0 kHz |
| Repeatability | 2% |
| Transverse Sensitivity (max) | 5% |
| Power Requirements | 2-wire loop power: 12 - 30 VDC at sensor terminals |
| Loop Resistance (max at 24 VDC) | 700 |
| Turn-on Time (4-20 mA loop) | 30 seconds |
| Grounding | Case isolated, internally shielded |
| Operating Temperature Range | 40 to +105 C |
| Vibration Limit | 250 g peak |
| Shock Limit | 2,500 g peak |
| Weight | 120 grams |
| Mounting | 1/4-28 UNF tapped hole |
| Output Connectors | 2-pin MIL-C-5015 (R6) or 4-pin M12 |
| Accessories Supplied | SF6 mounting stud; calibration data (level 2) |
| Full Scale Output (20 mA) | See Table 1 for options (e.g., 0.5 ips, 1.0 ips, 2.0 ips, 3.0 ips, 5.0 ips, 10 mm/sec, 20 mm/sec, 25 mm/sec, 50 mm/sec) |
| Model Selection Guide (Example) | PCC420Vx-yy-C
x: Output type (R=RMS, P=Peak)
yy: Full scale (05=0.5 ips, 10=1.0 ips, 20=2.0 ips, 30=3.0 ips, 50=5.0 ips, 10mm=0.4 ips, 20mm=0.8 ips, 25mm=0.9 ips, 50mm=1.9 ips)
C: Connector (R6=2-pin MIL-C-5015, M12=4-pin M12) |
| Connections (-R6 models) | Pin A: Loop positive (+)
Pin B: Loop negative (-)
Ground Shell |
| Connections (-M12 models) | Pin 1: Loop positive (+)
Pin 2: Loop negative (-)
Pin 3: N/C
Pin 4: N/C
Ground Shell |
| Maximum Loop Resistance (RL) Calculation | RL = (VDC power 10 V) / 20 mA |
| Minimum RL Wattage Capability | (0.0004 x RL) |
| Typical Loop Resistance & Wattage | 12 VDC: 100 , 1/8 watt
20 VDC: 500 , 1/4 watt
24 VDC: 700 , 1/2 watt
26 VDC: 800 , 1/2 watt
30 VDC: 1,000 , 1/2 watt |
